How do I replace the lamp?
Loosen the screws securing the lamp to the projector. The screws
do not come all the way out.
Before you replace
the lamp, let the projector cool down for at least one hour so the lamp will
not be hot.
Warning: Let the lamp fully cool before
replacing it to avoid injury.
You can replace the lamp while the projector is mounted to the
ceiling, if necessary.
Turn off the projector and unplug the power cord.
Allow the projector lamp to cool down for at least one hour.
Use the screwdriver included with the replacement lamp to loosen
the screw securing the lamp cover.
Warning: If the lamp is broken, glass
fragments may be loose inside the lamp chamber. Be careful removing any broken
glass to avoid injury. If the projector is installed on the ceiling, stand to
the side of the lamp cover and not underneath it; pieces of glass could fall
into your eyes or mouth when you open the lamp cover.
Slide the lamp cover out and lift it off.
Lift up the lamp handle and gently pull the lamp out of the
lamp(s) in this product contain mercury. Please consult your state and local
regulations regarding disposal or recycling. Do not put in the trash.
Gently insert the new lamp into the projector. If it does not fit
easily, make sure it is facing the right way. Press the handle down until it
locks into place.
Caution: Do not touch any glass on the lamp assembly to
avoid premature lamp failure.
Push in the lamp firmly and tighten the screws to secure it.
Replace the lamp cover and tighten the screw to secure it.
Note: Be sure the lamp cover is securely installed or the lamp will
not come on.
Reset the lamp timer to zero to keep track of the new lampís usage.
Published: May 29, 2013
Thank you for your feedback.
Return to Main FAQs Page