PowerLite Home Cinema 5030UB 2D/3D 1080p 3LCD Projector

Selected FAQ

Q:
When and how should I clean or replace the air filter?
A:
You need to clean the projector's air filter in the following situations:
  • The filter or vents get dusty.


  • You see a message telling you to clean it.
  1. Turn off the projector and unplug the power cord.


  2. Press in on the inner edge of the air filter cover to release the latch, then pull to remove.



  3. Pull the air filter out of the projector.



  4. Tap each side of the air filter 4 to 5 times to shake off any excess dust.



    Caution:
    Do not use excessive force when tapping the air filter, or it may crack and become unusable. Do not rinse the air filter in water, or use any detergent or solvent to clean it. Do not use canned air; the gases may leave a residue, or push dust and debris into the projector's optics or other sensitive areas.

  5. Vacuum the front of the air filter (the side with the tabs) to remove any remaining dust.



    Note: If dust is difficult to remove or the air filter is damaged, replace the air filter.

  6. Place the air filter back in the projector as shown.



  7. Close the air filter cover.

Replacing the Air Filter

You need to replace the air filter in the following situations:
  • After cleaning the air filter, you see a message telling you to clean or replace it


  • The air filter is torn or damaged

You can replace the air filter while the projector is mounted to the ceiling or placed on a table.

  1. Turn off the projector and unplug the power cord.


  2. Press in on the inner edge of the air filter cover to release the latch, then pull to remove.



  3. Pull the air filter out of the projector.



    Note: Air filters contain polypropylene. Dispose of used air filters according to local regulations.

  4. Place the new air filter in the projector as shown.



  5. Close the air filter cover.
Published: October 17, 2013

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page