Epson Stylus C84N Ink Jet Printer

Selected FAQ

Q:
Why am I getting the message Could not complete communicating configuration data when I send settings to the network adapter?
A:
This might happen when using a dial-up router. Run MS-DOS Prompt or Command Prompt from the computer in which EpsonNet WinAssist is installed, then enter the following command: >ROUTE_ADD_[the IP address of the network adapter]_[the IP address of the computer] (each underscore represents one space).

Example: >ROUTE ADD 192.168.192.168 22.33.44.55

Also, reinitialize the network adapter, then try again.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page