FX-2190N Impact Printer

Selected FAQ

Q:
Why does my printer print garbage from MS-DOS and Windows?
A:
Try the following if garbage prints:
  • Turn off the printer and computer. Disconnect and reconnect the printer cable at both ends. If a switch box is being used, remove it and connect the printer directly to the computer with a single cable. Turn the printer and computer back on. If you're still getting garbage, change the cable. We recommend a fully shielded cable, 6 feet or less in length.
  • Check to make sure the driver matches the printer emulation mode. You may be using the FX-2190 driver while the printer is set up for Okidata mode.
  • Check the character table settings. See Changing the Printer's Default Settings in the User's Guide.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page