PowerLite 61p Multimedia Projector

Selected FAQ

I connected an Elmo HV-110XG Document Camera to my projector using a VGA HD15 connection and I just see a blue screen with the message No Signal when I try to display an image from the document table source. What should I do?
Follow these steps:

  1. Make sure the Elmo HV-110XG Document Camera is turned on and connected to the projector.

  2. Turn on the projector.

  3. If the projector screen is flashing off and on, continue with step 4. If the projector screen is solid blue, skip to step 5.

  4. Connect the computer to the Elmo HV-110XG Document Camera’s HD-15 input port and switch the camera to Pass-Through mode. The projector screen should stop flashing and display the computer image.

  5. Access the projector’s Signal menu and change the input signal from Auto to Component Video. The Elmo HV-110XG Document Camera should sync with the projector and display an image from the document camera bed.

  6. Once an image appears, change the input signal to RGB (this will eliminate any pink casts in the image), then to Auto.

  7. Switch the source on the Elmo HV-110XG Document Camera to the document table.

  8. When you’re finished, exit the menu system.

Note: The Elmo HV-110 Document Camera will retain its new settings even when if you connect to a different projector.
Published: September 17, 2007

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page