PowerLite 835p Multimedia Projector

Selected FAQ

Q:
When I use Quick Connection Mode in the EasyMP NS Connection software to select the target projector to connect to over the network, I see the error message Cannot connect because there is no unused IP address. What should I do?
A:
If your projector is configured for both wired and wireless networking, make sure the wired network IP address is not on the same network segment as the wireless IP address on your computer. Reset the wireless IP address on the computer to a different network segment.
Published: April 2, 2010

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page