I can’t connect to the projector using NS Connection. What should I do?
Check the following:
Make sure you’ve installed the Epson 802.11g card correctly in the projector; see Starting EasyMP. If you have to reinstall the card, restart NS Connection or the program will not be able to detect the projector.
Make sure that you have sufficient wireless signal strength (above 50 percent). On a Macintosh, check the AirPort icon on the Macintosh menu bar. In Windows, see the documentation for your computer’s wireless card or adapter for details.
Make sure you aren’t projecting one of the EasyMP configuration screens. (You should see a message that the projector is ready to connect.) If you have to exit a configuration screen, restart NS Connection. If you’ve changed any settings for your projector or network, or restarted your computer, allow a minute or two for the connection to appear. If you’re using AirPort, try turning AirPort off and then on again.
Make sure that you’re trying to connect to the right network. In Windows, verify that you’ve enabled your computer’s connection to the access point or that your wireless card or adapter is enabled and its SSID is set to match the projector’s ESSID (for more details, see Configuring the Network Settings for Windows). On a Macintosh, click the AirPort icon at the top of your Macintosh desktop to make sure AirPort is turned on and the projector’s ESSID or your AirPort network is selected.
If you have an access point or AirPort base station and you’re not using DHCP, check your projector’s IP address on the Access Point mode advanced settings screen. The first three segments of the IP address should be identical to the first three segments of the IP address of your access point or base station. The last segment of the projector’s IP address should be close, but not identical, to the last segment of the IP address of the access point or base station.
If you’re not using DHCP, check your projector’s Gateway address on the projector’s Access Point mode advanced settings screen. It should be identical to the IP address for your