Epson Stylus Photo RX580 All-in-One Printer

Selected FAQ

Q:
What should I do if my Stylus Photo RX580 doesn't detect my photos placed on the scan bed when I use the reprint/restore function on the control panel?
A:
Check the following:
  • Make sure the scan bed glass is clean and free of finger prints, smudges, etc. (When cleaning the glass, spray the glass cleaner onto a cloth and then wipe the glass. Never spray glass cleaner directly onto the scan bed.)


  • Make sure the photos are placed on the scan bed correctly. See Placing Originals for Scanning.


  • Make sure the photos are no larger than 5 x 7 inches for one photo or 4 x 6 inches for two photos.


  • When copying two photos (up to 4 x 6 inches), place them 1/4 inch (5 mm) apart as shown below.

Published: February 28, 2008

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page