Epson MovieMate 30s

Selected FAQ

The power does not turn on. What’s wrong?
Check the following:

  • Make sure the main power switch is turned on.

  • If the Image On light is flashing green, Epson MovieMate is warming up. Wait for the picture to appear.

  • If the Image Off light is flashing orange, Epson MovieMate is cooling down. Wait until the light stops flashing, then press the  Power button to turn on Epson MovieMate.

  • If the  Power light is green and not flashing, Epson MovieMate is operating normally. Make sure the lens cover is off. Press the  button on Epson MovieMate or on the remote control to make sure the picture hasn’t been turned off temporarily.

  • Turn off the main power switch and make sure the power cord is securely attached at both ends. Try using a different power outlet.

    If the power cord has been damaged, turn off Epson MovieMate, disconnect the power cord, and contact Epson support.
Published: September 28, 2006

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page