Epson MovieMate 30s

Selected FAQ

Q:
Why are images fuzzy or out of focus?
A:
Check the following:

  • Adjust the focus using the focus ring.



  • Make sure the lens cover is off.


  • Make sure the Epson MovieMate is placed the correct distance from the screen; no closer than 2.4 feet (73 cm) and no farther than 37 feet (11.37 m).


  • There may be dirt on the lens. To remove dirt or smears, use lens cleaning paper to gently wipe the lens.


  • Make sure the lens is not fogged by condensation. If you’ve just moved the Epson MovieMate from a cold environment, wait approximately one hour before using it. If condensation forms, turn on the main power switch, then wait an hour or two before use.


  • Adjust the Sharpness setting. See Adjusting Picture Quality.


  • If you’re using the Keystone adjustment, be aware that it lessens image quality. You may wish to decrease the projection angle to reduce the amount of keystone correction needed, or use the quick image adjustment dials to position the image.
Published: September 28, 2006

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page