Epson PowerLite Pro Cinema 810 HQV

Selected FAQ

Q:
What should I do if I see the message No Signal?
A:
Check the following:

  • Press the Source button on the projector or one of the Source buttons on the remote control to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.


  • Press the Blank button on the remote control to make sure the picture hasn’t been turned off temporarily.


  • Check that the power light is green, not flashing, and the lens cover is off.


  • The projector may be in standby (or sleep) mode. If the power light is orange, press the Power button to turn the projector back on.


  • Make sure your video equipment is turned on.


  • Make sure your cable(s) are connected correctly See Connecting the Cables for more information.
Published: November 30, 2006

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page