Epson PowerLite Pro Cinema 810 HQV

Selected FAQ

Q:
I replaced the projection lamp, but I still see the message Replace the lamp. How do I clear this message?
A:
You need to reset the lamp usage timer. After replacing the lamp, plug the projector back in, turn on the power switch on the back, and press the Power button. Then follow these steps to reset the lamp usage timer:

  1. Press the Menu button on the projector or remote control.


  2. Use the menu navigation buttons to open the Reset menu, then select Reset Lamp Hours.


  3. When you see a confirmation prompt, highlight Yes and press the Select button.


  4. When you’re finished, press the Menu button to exit.


The lamp usage timer doesn’t register until you’ve used the lamp for at least 10 hours.
Published: November 30, 2006

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page