PowerLite 1815p Multimedia Projector

Selected FAQ

When I use Quick Connection Mode in the EasyMP NS Connection software to select the target projector to connect to over the network, I see the error message Cannot connect because there is no unused IP address. What should I do?
If your projector is configured for both wired and wireless networking, make sure the wired network IP address is not on the same network segment as the wireless IP address on your computer. Reset the wireless IP address on the computer to a different network segment.
Published: April 2, 2010

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page