PowerLite Home Cinema 1080 Projector

Selected FAQ

What should I do if I see the message No Signal?
Check the following:

  • Press the Source button on the projector or one of the Source buttons on the remote control to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.

  • Make sure your video equipment is turned on and set up to output video to the port the projector is connected to.

  • Make sure your cable(s) are connected correctly. See Connecting the Cables.
Published: March 8, 2007

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page