Epson MovieMate 72 Projector

Selected FAQ

No image appears. What should I do?
Check the following:

  • Make sure Epson MovieMate is turned on (the   light is green and not flashing). If the Image On light is flashing green, wait for Epson MovieMate to warm up.

  • Make sure the lens cover slide is open.

  • The image may be off the screen. Use the quick image adjustment dials to adjust its position. See Adjusting the Picture.

  • Press the   button on Epson MovieMate or on the remote control to make sure the picture hasn’t been turned off temporarily.

  • Make sure the region code on the DVD is 1.

  • Check the  lamp warning light. If it is flashing orange or red, you need to replace the lamp. For instructions see Replacing the Lamp.

  • The Screensaver feature turns off the picture if a still image is projected for more than 15 minutes. See Saving Power for instructions on adjusting Sleep settings.

  • Make sure the top section is rotated all the way to the front or back and not turned at an angle.

  • Lens facing the disc slot

    Lens opposite the disc slot

    Top section turned at an angle

  • If you’re using external video equipment, check the following:

    • Make sure the external video equipment is turned on, connected, and set up correctly.

    • Press the  button on Epson MovieMate or on the remote control.

    • Press the  or Play button on the external equipment.

    • Make sure you don’t have cables connected to more than one video port. You can use only one connection at a time. See Viewing Video from External Devices for more information.
Published: September 18, 2007

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page