Epson Stylus NX130 All-in-One Printer

Selected FAQ

Q:
What can I do about paper feed problems?
A:
Check the following:

  • If paper doesn't feed, remove it from the sheet feeder. Reload it against the right side, behind the tab, then press in the tab on the edge guide and slide it against the paper and make sure it's not too tight. Make sure the paper is not above the  arrow mark inside the edge guide.


  • If multiple pages feed at once, remove the paper from the sheet feeder, fan the edges to separate the sheets, then reload it.


  • If you're printing on both sides of the paper, try loading fewer sheets.


  • If it's wrinkled when it ejects, the paper may be over-saturated or too thin. (If the paper is over-saturated, make sure you select the correct media type in the product software).


  • Make sure you use new, smooth, high-quality paper, that is not curled, creased, old, or too thin. Make sure to load it printable side up.


  • Do not load paper with holes punched in it.


  • Do not load paper that is too thick for the product.


  • If paper is jamming when you are inserting only one or two sheets, try loading more pages at a time. However, do not load more than the recommended number of sheets.

    Paper type
    Load up to
    this many sheets
    Plain paper 100
    Epson Bright White Paper
    Epson Presentation Paper Matte
    80
    Epson Premium Photo Paper Glossy (4 × 6 inches only)
    10
    Epson Photo Paper Glossy
    Epson Premium Photo Paper Glossy
    Epson Premium Photo Paper Semi-gloss
    Epson Premium Presentation Paper Matte
    Epson Premium Presentation Paper Matte Double-sided
    Epson Photo Quality Self-Adhesive Sheets
    Epson Iron-On Cool Peel Transfer paper
    1


  • If the paper jams, follow these steps to clear it:

    1. Cancel the print job, if necessary.


    2. Gently pull any jammed paper out from the output tray or sheet feeder.


    3. If paper is stuck inside, press either of the copy buttons to eject the paper. Remove the jammed paper, including any torn pieces. If the error is not cleared and the error light is still lit, continue with the next step.




    4. Press the  power button to turn off the product.




    5. If paper remains near the sheet feeder, press the paper feed roller lever inside the sheet feeder to release the jammed paper, then carefully pull it out.




    6. Raise the paper jam cover, carefully remove the jammed paper, then close the paper jam cover.




    7. Press the  power button to turn the product back on.




    Note: The product won't operate properly if it's tilted or at an angle. Place it on a flat, stable surface that extends beyond the base in all directions.
Published: May 17, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page