Loading Paper
Follow these steps to load paper in the printer.
 |
Lower the output tray and slide out the extension. Next, slide the left edge guide so
that the distance between the edge guides is slightly wider than the width of your paper. |
 |
Fan a stack of paper; then tap it on a flat surface to even the edges. |
 |
Load the stack of paper with the printable side up and the right edge against the
right side of the sheet feeder. Then slide the left edge guide against the left edge of
the paper. |
 |
 |
Note: |
|
|
 | Always load paper into the sheet feeder short edge first. |
|
|
|
| Make sure the paper stack fits under the arrow mark inside the
left edge guide. |
|
| If the paper is curled, flatten it or curl it slightly toward the
opposite side before loading. Printing on curled paper may smear your printout. |
| If ink smears on your documents when printing on thick paper, set
the adjust lever to the "+" position. To change the setting, open the printer
cover and position the lever as shown in the illustration. |
Return the lever to the "0" position before printing on paper of
normal thickness. Leaving the lever in the "+" position may cause gaps in the
printed image.
About special media cleaning
sheets
Cleaning sheets packaged with EPSON special media should not be used with this
printer. The cleaning function performed by these sheets is not necessary with this type
of printer, and the sheets could jam inside it.
|
